C Variety Flex-Flex Couplings
The C Form coupling includes two flex hubs, one sleeve and one accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Type coupling include one particular flex hub, a single rigid hub, 1 sleeve, one accessory kit consisting of seals and snap rings.
Features
Straightforward and reasonably priced type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Accessible as vertical and horizontal couplings
Broad variety of exclusive variations for instance full-flex, flex-rigid mill motor
Regular configurations are available on the shelf
Ordering Info
Application: Driver and Driven.
Variety and size of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Details
Puller Holes are standard on sizes four via 12.
Puller Holes can be found for sizes 7/8 by means of three.5 at an additional charge.
The BSE (distance Among Shaft Ends) could differ between G and G1.
Interference bores with no set screws are common unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek the advice of Engineering Segment.
Greater sizes can be found, please check with Technical Support.