Material Dealing with Power UNIT one
General Description
This energy unit is intended for your fork lift market, consisting of extremely effective gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down motion are controlled through the lever from the manual release valve, which can be outfitted with an electrical switch to activate the motor. The lowing speed is managed by the strain compensated flow handle valve.
Distinctive Notes
1. The duty of this energy unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic parts concerned ahead of set up of the energy unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should also be clean and cost-free of impurities, N46 hydraulic oil is suggested .
four. Oil shifting is needed soon after the initial one hundred operation hours, afterwards the moment just about every 3000 hrs.
five. The electrical power unit proven is built to be mounted horizontally.

Materials Managing Power UNIT 2
Common Description
This power unit capabilities electrical power up gravity down circuit. Activate the start out solenoid to begin the motor to lift the machine. The lowing movement is activated by the solenoid valve with all the lowering speed managed from the pressure compensated flow management valve. Solutions of this series could be extensively utilized in the market of logistic units like fork lift, mini lift table, and so forth.
Special Notes
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean each of the hydraulic parts concerned ahead of mounting the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which need to also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil shifting is needed immediately after the preliminary 100 operation hrs,afterwards after each and every 3000 hrs.
five. The power unit need to be mounted horizontally.